-Gila Region Community News, Calendar, Forum-

Reader Supported Silver City News & SW New Mexico, Grant County NM, Gila NF
* Login   * Register

* FAQ    * Search

All times are UTC - 7 hours

News     Columns     Food: Growing, Fixing     Features     Water     Health     Business     Education     DIY & How-tos     Classifieds     Forum     Home 

Silver City Food Coop



We Are Reader Supported
Your recurring contribution goes to support the Forum, Calendar, and Email List, which exists to further local, sustainable, place-based community.
MONTHLY RECURRING GIFT
    Bill Me Now For: $

ONE-TIME GIFT
Bill Me Now For: $

You may also mail a check or cash to
John Crow
PO Box 1792
Silver City, N.M. 88062


Get your ad here








Post new topic Reply to topic  [ 3 posts ] 
Author ------ Message
 Author: Barbara Fleming
PostPosted: Tue Jul 02, 2013 9:55 pm 
We have a 1940's house with a single car garage that had been roughly converted to an office before we bought it. Now we're trying to make it really nice. Most of the problems have found solutions, but the floor still stumps us. The space is 18' x 8.5' (was a single car garage) and the cement floor is about 2.5" lower in front than in back. It's also not level side to side, but we haven't measured that. The back to front drop is obviously for drainage; no clue why the side to side difference. We'd like to level it by just pouring more concrete on top of the existing concrete and letting it self-level. I'm oversimplifying but that's the idea. A stone foundation runs from front to back on both sides and of course we would have to raise the entry door (a normal exterior door) at the front. Over the years we've been discouraged from doing this but I'm not clear anymore whether there is a structural reason not to do this or just because it would be a hassle and probably expensive, and would not have been worth it to the various people we've informally consulted. Advice or suggestions (including recommendations on contractors we might contact about this) would be much appreciated.


Top
 Profile  
 
 Author: cherokeewoman
PostPosted: Wed Jul 03, 2013 6:12 am 
Barbara
I have run across this same problem on many homes where garage has been converted
You might try (shown to work in several cases) building wooden frame with 2x6 at lowest
level and 2x4 at highest level (top and bottom) as you run joist across build up sides accordingly
use OSB or CDX as subfloor and then lay laminate floor on top (sturdy and beautiful) before you
start anything lay vapor barrier over cement (just a precaution). Pouring new cement is cost
prohibitive and may or may not work (depends on how good the person you get to do it is) things
dry here so fast cement has tendency to crack and then you have whole new set of problems.


Top
 Profile  
 
 Author: EGGreen
PostPosted: Fri Jul 05, 2013 12:45 pm 
For what it's worth, I'm no 'professional', however. . .
I bought a ("real" fixer-upper)cinder block house which was built on 3 slabs, one of which tipped south, and the one corner of it tipped east. Quite a bit. For flooring, I mixed and poured self leveling cement, with about a 1/2 gal of elasto- something or other I got at Foxworth, to keep it from cracking when it dried. It took quite a lot of 5 gal pails of self leveling cement/mix. I would dump a pail full in each corner, let it dry completely, then do it again, and again-- My floor was really bad. . . but, I finally got 'er done! 7 buckets in 1 corner, 5 in another, and then I don't know how many all inbetween. On top of that went the compressed vapor barrier stuff, then laminate flooring! It looks good. Has been good for the past 7 years, so, just tossing these "how I did it" ideas out there. Good luck!!

_________________
Create a great day! Gale


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 7 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:

Gila River Festival Ad


Silver City & Southwestern New Mexico Monthly Community Calendar

Click To Create A New Calendar Event
<<

Community Events
Week of November 24, 2017

>>

24
Arte Chicano de San Vicente @ SC Museum
Qi Gung for Health at the Lotus Center
Fiber Arts Collective's Holiday Fiber Art Sale
Holiday Fiber Art Sale
Women's Al-Anon Meeting: Women Embracing Recovery
Pet Central Thrift Store
Hapkido Class
Community Bike Ride @ The Bike Works
Our PAws' Cause Thrift Store
25
Arte Chicano de San Vicente @ SC Museum
Tai Chi Chuan
Fiber Arts Collective's Holiday Fiber Art Sale
Shop Small Saturday
Lighted Christmas Parade
Ecstatic Dance
26
Arte Chicano de San Vicente @ SC Museum
New Hope Al-Anon Family Group
27
Hapkido Class
Tai Chi Chuan
Laughter Yoga at 1 p.m. at the Lotus Center
28
Arte Chicano de San Vicente @ SC Museum
Silver City Rotary Club Meeting
International Folk Dancing
Hapkido Class
Compassionate Friends Gathering
Tai Chi at Lotus Center
Wine & The Word @The Toad Brewery
Creative Writing for Beginners-free workshop
ToSC Council Meeting- Agenda
Our Paws' Cause Thrift Store
29
Arte Chicano de San Vicente @ SC Museum
Hapkido Class
Tai Chi Chuan
Insight Buddhist Meditation
Gin Rummy
Progressive Gov Candidate Meet & Greet
Wednesday Evening Al-Anon Family Group Meeting
Concert Band of the Southwest “Not Just A Holiday Concert”
30
Arte Chicano de San Vicente @ SC Museum
Our Paws' Cause Thrift Store
Volunteer at The Bike Works 3-7pm
Tai Chi at Lotus Center
Blooming Lotus Meditation
Women's Al-Anon Meeting: Women Embracing Recovery
Pet Central Thrift Store
Our Paws' Cause Thrift Store










News     Columns     Food: Growing, Fixing     Features     Water     Health     Business     Education     DIY & How-tos     Classifieds     Forum     Home 
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group